FiOS/networking question

[Dan Jenkins]

Ben Scott wrote:

> The LinkSys will have a LAN IP address you can point a browser to.
> By default, it will be 192.168.1.1.  If that doesn't work, the easiest
> thing to do is:
>
> 1. Unplug everything from the LinkSys
> 2. Plug a single computer, set to be a DHCP client, into the LAN side
> of the LinkSys
> 3. Plug in power while holding down the RESET button (back panel, 
> recessed)
> 4. After several seconds, you should see the LinkSys start cycling.
> Let go of button.
> 5. Tell your DHCP client to renew its lease.  It should get 
> 192.168.1.something.
> 6. Point the client to http://192.168.1.1
>
>  You'll then be able to turn off DHCP on the LinkSys, and change it's
> IP address to something appropriate for your LAN.  You can then plug
> everything back into the LinkSys.

The Linksys default username will be "admin" and the default password 
will be "password".

-- 
Dan Jenkins (dan at rastech.com)
Rastech Inc., Bedford, NH, USA --- 1-603-206-9951
*** Technical Support Excellence for over a Quarter Century